Operator`s manual

r i
RETAINER
SPRING
FIGURE 39
TRANSAXLE
PULLEY
BELT GUIDE
BRACKET
GUIDE
RETAINER
SPRING
2,. REPLACE TRACTOR MOTION DRIVE BELT
The tractor Drive Belt may be replaced without tools, Park
the tractor on level area. Engage Parking Brake, NOTE:
BELT INSTALLATION DECAL UNDER LEFT FOOT-
R EST,
a Remove mower, (See Mower Section, page 13),
b, Remove two Retainer Springs from Belt Guide Bracket
below Transaxte Pulley, Remove Bracket (Fig° 39},
c, Swing Belt Guides away from Belt, toward rear of trac_
tot (Fig,, 39)°
d. Rotl Belt over top of Transaxte Pulley.
e= Roll Belt over Engine Pulley and off Idler (Fig. 4i)
f. Release Parking Brake. Pull Belt as far as possible over'
top of Clutch Pulley.
g. Reset Parking Brake= Pull Belt over top of Clutch Pulley
(Figo41),
h,, Pull Belt out through Shift Gate to remove flora trac-
tor (Fig, 40),
Instatl Belt by reversing above procedure. NOTE: RE.
PLACE ONLY WITH BELT LISTED IN MANUAL,
BELT
FIGURE 40
SHIFT GATE
R.H. SIDE
ENGINE
PULLEY
CLUTCH
PULLEY
DRIVE BELT
SCHEMATIC
LH. SIDE
BELT GUIDE
REAR
VIEWED FROM BOTTOM OF TRACTOR
FIGURE 41
-18-