Operator`s manual

FIGURE 44
SCRE
FIGURE 45
WASHERS
HUB
CAP
KLIP RING
6 TIRE CARE
a, Maintain tire pressure in front at 14 PSI and rear tires
at 12 PSI,
b_ Keep tires free of gasoline, oil, of insect control chemi-
cals which can destroy rubber,
c, Avoid stumps, stones, deep ruts and other hazards that
may cause tire damage.
d,. Removing front wheel for tire repair (Fig,. 44).
--- Block up front axle securely.
-- Remove Hub Cap. Klip Ring and Washers to altow
wheel removal.
-- Repair tire and reassemble. Rep(ace Washers and snap
Klip Ring securely in axle groove,, Replace Hub Cap=
e. Removing rear wheel for tire repair,,
-- Block up rear axle secure)y_
-- Remove Hub Cap, Klip Ring and Washers_
-- Repair tire and reassemble. Replace Tire, Washers,
Klip Ring and Hub Cap.
WHEN MOUNTING TIRES, UNLESS
BEADS ARE SEATED, OVERINFLATION
CAN CAUSE A FATAL EXPLOS|ON.
WHEN REPLACING WHEELS ON THE
TRACTOR THEY MUST BE MOUNTED
WITH THE LONG HUB SIDE TOWARD
THE CENTER OF THE TRACTOR. IN-
CORRECT INSTALLATION COULD AF-
FECT LATERAL STABILITY. SEE FIG,
47.
7.
8_
FINISH
Keep tractor finish and seat free of gasoline, oi_ insect
chemicals or battery electrolyte, Protect painted surfaces
with automotive type wax,
HOOD REMOVAL
a Lift Hood Disconnect Headlight Wiring Connection
(Fig. 46),,
bo Unscrew one Screw at rear of each Side Panel (Fig.
45L
c Pivot Hood and Side Panel forward and lift off tractor
(Fig. 46).
d To replace, reverse the above procedure.
WIRE
CONNECTION
FIGURE 46
..._.._.....pLOr- G ,..___...I
FIGURE 47 - 20-