Operator`s manual
5. InstallBatteryusing:two Int./EXtLockwashers,twoWing
Nuts(shownfullsizebelow)and
_iiiii _'_I_II'_
©
two Battery Bolts and one Terminal Guard found in Bag of
Parts,
a. Using the slotted hole on one side of the Battery Support
(Fig, 4) "insert one Battery Bolt, head of Bolt down,
Fasten the Battery Bolt to the Terminal Guard using
lntoiExt Lockwasher and Wing Nut as shown in Fig 4,
I NT./E X T,
LOCKWASHER
WING
NUT
WING NUT
INT./EXT,
;KWASHER
ACCESS
DOO R
TERMINAL
GUARD
TERMINAL
ACCESS DOOR
;ATTERY BOLT
BATTERY
SUPPORT
FIGURE 4
b_
Wing Nuts securely by hand (Fig, 4).
NOTE: USE TERMINAL ACCESS DOORS (FIG, 4) FOR:
1., Inspection for secure connerJtions (tighten hardware).
2o Inspection for corrosion_
3. Testing battery°
4. Jumping (if required).
5. Charging (if required),
BATTERY
BOLT
/
SLOTTED
HOLE
maining tnt,/Ext., Lockwasher and Wing Nut, Tighten _ ./----"-_ 1t2" HEX NUT
WHEN NOT IN USE, KEEP TERMINAL
ACCESS DOORS CLOSED°
64 Replace Air Intake Duct (Fig, 2)° Make sure bottom lip of
Duct sits between battery and lip of Battery Tray
7.. Remove plastic on Tractor Hood.
8. Close Hood.
9. Install Steering Wheel.
NOTE: POSITION FRONT WHEELS FORWARD°
a, Remove 1/2" Hex Nut and 2 = 1/4" Dia. Washer from
Steering Colum0 (Fig° 5}.
b, Position Steering Wheel over Steering Whe.el Insert°
c Secure Steering Wheel to Steering Column using 2- 1/4"
Dia, Washer and Hex Nut (Fig, 5),
do Snap Steering Wheel Cap in place on Steering Wheel.
Steering Wheel Cap found in Bag of Parts..
wt0., Install Seat_
a, Mount Seat Pivot Bracket to Fender Strap Studs using
two Lock Nuts 3/8 - 16 (Fig 5A). Seat Pivot Bracket
and Lock Nuts found in Bag of Parts, Tighten Nuts
securely.
bo Mount Seat Pan to Seat Pivot Bracket using two Shoul-
der Bolts 5/16 - 18 and two Lock Nuts 5/t6 - 18 (Fig.
5A) (head of Bolts to outside)° Bolts and Lock Nuts
found in Bag of Parts. Tighten Bolts and Nuts securely,
-5-
SEAT
SHOULDER BOLT
AND LOCK
/
.---_--STEERING WHEEL INSERT
COLUMN
FIGURE 5
LOCK NUTS
3/8, 16
SEAT PIVOT
BRACKET
SHOULDER BOLT
"" AND LOCK NUT
\
FIGURE 5A