Specifications

I U--AI._JIU:51 MU I IUN UUIt I hull. I.r.v r..h
The n_otion control lever hasbeen preset
at the factory and adjustment Should not
be necessary. ' : "
: for any reason the motion control lever
will not holdits position while at a selected
speed, it may be adjusted at the friction
pack located on the right side of transmis-
sion.
• Park tractor on level surface. Stop trac-
tor by tuming ignition key to "OFF" posi-
tion, and engage parking brake.
• Adjust motion control lever by tightening
adjustment Iocknut one half (1/2) rum.
NOTE: If for any reason the effort to
move the motion control lever becomes
too e_,cessjve, reverse the above adjust-
ment procedure by loosening Iocknut 114
to 112turn. ........ ......
Road test tractor after adjustment and
repeat procedure if necessary.
TRANSMISSION REMOVAL/REPLACE-
MENT
Should your transmissionrequire removal
for service or replacement, itshould be
purged after reinstallationand before
operating the tractor. See =PURGE
TRANSMJSS!ON" in the Operation section
of thismanual.
• Adjustment
Locknut
TO ADJUST STEERING WHEEL ALIGN-
_ENT
tfsteering wheel crossbars are not hori-
zontal (left to right) when wheels are posi-
tioned straight forward, remove steering
wheel and reassemble per instructions in
the Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not
adjusta_ yo_ tractor. If damage has
_cur-r'edt_affect-the front wheel toe-in or
:am ber_ont_ct your nearest authorized
;ervice center.
26
_TO REMOVE WHEELS FOR SERVICE
• IdlOCK up axle securely.
• Remove axle cover, retainingringand
washers to allow wheel removal (rear
wheel contains a square key - Do not
lose).
• Repair tireand reassemble.
• On rear wheels only:align groovesin
rear wheel hub and axle. Insertsquare
key.
• Replace washers and snap retaining
ringsecurely in axle groove.
• Replace axle cover.
NOTE: Toseal tire puncturesand prevent
flattires due to slow leaks, tire sealant
may be purchased from your local parts
dealer.Tire sealant also prevents tire dry
rotand corrosion.
Washers
Retaining
Ring
Axle Cover Square Key
(Rear Wheel Only)
TO START ENGINE WITH A WEAK
BATTERY
ACAUTION: Lead-acid batteriesgener-
ate explosive gases. Keep sparks,flame
and smoking materials away from batter-
ies. Alwayswear eye protectionwhen
aroundbatteries.
If your batteryis too weak to startthe
engine, it should be recharged. (See
"BATTERY, in the MAINTENANCE sec-
tion of this manual).
If =jumper cables"are used for emergency
starting,follow this procedure:
IMPORTANT: Yourtractor Is equipped
with a 12 volt negative groundedsystem.
The other vehicle must also be a 12 volt
negativegroundedsystem. Do not use
your tractorbatteryto start other vehicles.
TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable to
•the POSITIVE (+) terminal of each bat-
tery, taking care not to short against
chassis.
• Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery.