Owner`s manual

MAINTENANCE SCHEDULE _"_/'_'_ "_'_/_/.,_¢_ ''
DATES
_/ ///
Check I_rat or pre_ne.e _
T Intedock Systems
ChockforLooseFaS_r. J I/'7 t,/
A, Sh_pe,'VRep_aceMowarBlades 1_4
Lubrk_t_n emil _
T Check BatteryLevel
R Clean _tte W and Te,l_lnals IbS I_
Check Trans_xle Cooling
•_iust e_ad8 BeR(s)Ter.s_n l,/s
Adjust Motion Drive Belt(s) Ten.on _s
Clean Air Screen I_2
G InspoctMuC'fler/SparkAt,ester b/
N I ReplsoDOil _r (If equipped) t_=
E ! Clean Engin_ C_ing Fir_ _=
nepl_ _r Fi_erpaper Cartridge IV#'= l
Replace Fuel Filter t,_
I - Cl',_e*l_ mete of_m wP_m operatkng vn_" s hee_ Ioa_l _- In _¢l_h _**N_ tempemlu_. 5. ff equll:_¢_ w_h e,dl_tab_ _.
2 - S_vIc_ mor_ ofl_ wh_'_ op_rat,_ k_ d_ny or d_ty ¢ondfll,OnL
GENERAL RECOMMENDATIONS
The warranty on this tractordoes not cover
items thathave been subjected tooperator
abuse or negligence. To receive fullvalue
from the warranty, operator must maintain
tractor as instructed in this manual.
Some adjustments will need to be made
bedodicelly to propedy maintain your
tractor.
ALladjustmentsin the Service and
Adjustments section of this manual should
be checked at teastonce each season.
• Once a year you should replace the
spark plug, clean or replace air filter, and
check blades and belts for wear. A new
spark plug and clean air tilter assure
proper air-fuel mixture and help your
engine run better and last longer.
BEFORE EACH USE
1. Check engine oil level.
2. Check brake operation.
3. Check tire pressure.
4. Check operator presence and
interlock systems for proper operation.
5. Check for loose f_steners.
e - P_o(mq_re_l tl e_JIppe_ _,,_J_r,_almenlnce-kee _at,e_.
7 - Tight _, _ont aad_ _4o_ bolt Io 3_ fl*.lf0e, r_x*mum,
DO not o_ec,_",te_,
LUBRICATION CHART
®Tie RodBall Joints
1_Spindle _ _ _) Spindle
Zerk_ ............ _erk
_, _.v t. "=-i-,t ;,
_Fron, Wheel L._.'.:_,..,_ Wheel
Beadng -,_ 3eadngZerk
Zerk
_Steedng.{./_ J
Sector/\ _
Teeth
• C _J. , .:.
Tran_axlo I '
Fluid "_--_
_) SAE 30or I0w30 motor oil
(_ GeneralPurpose Grease
_) Refer to Maintenance "ENGINE"Section
® Spraysiliconelubdant (Move Boots to
Lubdcate)
IMPORTANT: Do not oil or grease the
pivot points which have special nylon
bearings. Viscouslubricants will attract
dust and dirt that will shorten the life of
the self-lubricatingbearings. If you feel
they must be lubricated, use only a dry,
powdered graphite type lubricant
18sparingly.