Owner`s manual

ASSEMBLY
UNPACKCARTON
! _ CAUTION: Be careful of exposed
staples when handling or disposing of
cartoning material.
ii ,,H,IH H III
IMPORTANT: WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLE(S).,
- Cut cable ties securing handle column°
o Slowly lift handle column and iay it over tiller°
. " Remove packing from carton. Hardware pack is found
in folded cardboard packing.
= S!]de handle cotumn onto handle mount,.
ASSEMBLE HANDLE (See Fig. 2)
= Slide reverse rod through hote in reverse rod bracket
as shown.
• Slide bushing over lower reverse rod and snap into
bracket hole.
• Attach reverse rod bracket to handle column using two
(2) carriage bolts and two (2) flange tocknuts.
NOTE: Make sure tine control cable is routed in front of
reverse rod bracket.
• Insert plastic cable clip into hole in handle column.
• Route tine control cable through plastic cable clip on
handle column,
• Remove packing material from handle assembly.
• Cut away carton.
o Cut cable ties securing tiller to skid. Remove tiller from
skid by pulling backwards.
ASSEMBLE REVERSE ROD (See Fig. 2)
o Secure upper reverse rod to lower reverse rod using
clevis pin, washer and cotter pin.
INSTALL DEPTH STAKE ASSEMBLY
(See Fig. 3)
• Insert stake support between engine bracket halves
with stake spring down,
NOTE: It may be necessary to loosen nut "A"°
• Bolt stake support to engine brackets with bolts, {ock
washers and nuts. Tighten securely. Also tighten nut
"A" if it was necessary to loosen.
° Depth stake must move freely, if it does not, loosen
support bolt.
HANDLE HEIGHT
• Handle height may be adjusted to better suit operator.
(See HANDLE HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better handle your
tilting conditions (See "FINE ARRANGEMENT" in the
Service and Adjustments section of this manual).
TINE OPERATION
• Check tine operation before first use. (See "TINE
OPERATION CHECK" inthe Service and Adjustments
section of this manual).
TINECONTROLCABLE
HANDLE MOUNT
TINE CONTROL
COLUMN
TINE CONTROL CABLE
CARRIAGE
BOLTS
CABLE
UPPER
REVERSE
ROD
REVERSE
ROD
LOWER
REVERSEROC
FIG. 2
CLEVIS
PIN
FLANGE
LOCKNUTS
ENGINE BRACKET
_LVES
DEPTH STAKE
IUPPORT
DEPTH
STAKE
SUPPORT BOLT
HEXBGLTS,
'LOCK WASHERS, AND HEX NUTS
RG. 3