Owner`s manual

NTENANCE
MUFFLER
Do not operate tiller without muffler, Do not tamper with
exhaust system, Damaged mufflers or spark attesters
could create a fire hazard, inspect periodically and re-
place if necessary. If your engine is equipped with a spark
arrestor screen assembly, remove every 50 hours for
cleaning and inspection. Replace if damaged.
SPARK PLUG
Replace spark plugs at the beginning of each tilling sea-
son or after every 50 hours of use, whichever comes first.
Spark plug type and gap setting is shown in "PRODUCT
SPECIFICAT!ONS" on page 3 of this manual.
TRANSMISSION
Your transmission is seated and will only require lubrication
if serviced.
CLEANING
• Clean engine, wheels, finish, etc, of alt foreign matter.
- Keep finished surfaces and wheels free of all gasoline,
oil, etc.
. Protect painted surfaces with automotive type wax.
We do not recommend using a garden hose to dean your
unit unless the muffler, air filter and carburetor are covered
to keep water out. Water inengine can result in ashortened
engine life.
SERVICE AN ADJUSTMENTS
CAUTION: Disconnect spark plug wires from spark plug and place wire where it cannot come intocontact with pEug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 22)
Select hand{e height best suited for your tilting conditions,
Handte height will be different when tiller digs into soil.
, First loosen handle lock ]ever,
• Handle can be positioned at different settings between
"HIGH" and "LOW" positions,
• Retighten handle lock Iever securely after adjusting,
HANDLE
LOCK
LEVER
HANDLE (LOW
POSITION}
_HANDLE(HIGH
_:_PosmoN)
FiG, 22
TIRE CARE
• Maintain 20 pounds of tire pressure, If tire pressures are
not equal, titler will pull to one side,
° Keep tires free of gasoline or oil which can damage
rubber,
TO REMOVE WHEEL (See Fig, 23)
• P{ace blocks under transmission to keep tilter from tip-
ping.
• Remove outer side shield (See Fig. 10).
° Remove hairpin ctip and clevis pin from wheel,
• Remove wheel and tire.
• Repair tire and reassemble.
FIG. 23
15