Owner`s manual

TROU NG POINTS
Illll I IIIIIIIIIIIIIIIIIIII IIIIII IIII IIIIIII1[I I I IJ IIL[IIIUIIIII I II I II11111 II I I
CAUSE CORRECT|ON
PROBLEM
i
Will not start
Hard to start
ii,lll ii i ii llllllll.=ll
Loss of power
Engine overheats
Excessive bounce/
difficult handling
lllliH i i i i i
Soil balls up or clumps
i iH
Engine runs but tiller
won't move
Engine runs but labors
when tilling
Tineswill not rotate
• H IlllIIlll,ll I I I •1 I
i. Out of fue!.
2. Engine not _CHOKED" properly.
3. Engine flooded.
4. Dirty air cleaner. : i :
5, Water in fuel
6, Cloggedfueltank.
7, Loosesparkplug wire.
8. Badsparkplugorimpropergap,
9. Carburetoroutofadjustment.
1. Throttlecontrefnot setproperly,
2, Dirtyair cleaner.
3, Badspark plugorimpropergap,
4. Staleor dirtyfuel.
5. Loosesparkplugwire.
6, _ Carburetoroutof adjustment,
UHIHIJIIHIJNII II :
1, Engine is Overloaded.
2. Dirty air cleaner.
3. Low oil feveltdirtyo[I.
4. Faulty spark plug. :_
5. Oil in fuel. ......
6. Stale or dirtyfuel.
7. Water in fuel.
8. Clogged fuel tank.
9. Spark plug wire loose.
10. Dirty engine a[r screen.
11. Dirb!/clogged muffler.
12. Carburetor outof adjustment.
13. Poor compression.
1. Low oil level/dirty oil.
2. Dirty engine air screen.
3. Dirty engine.
4. Partially ptugged muffler.
5. Improper carburetor adjustment.
I. Ground too dry and hard.
1..Ground too wet.
r.llfffllrnrmliHi i
1. Drive control bar is not engaged.
2. V-belt not correctly adjusted.
3. V-heir is offpulley(s).
1. Tilling too deep.
2. Throttle control not properlyadjusted.
3. Carburetor out of adjustment.
t.
2.
4,
5,
6.
7.
8,
9.
1.
Fillfuel tank,
See '3"0STARTENGtNE"in Operationsect[on,
.Waitseveralminutesbefore attempt[ngto start,
Replaceair cleanercartridge.
Drainfue!tank andcarburetor,andrefilltankwith
freshgasoline. ....
Removefueltankand clean.
Makesuresparkplugwire isseatedpropedyon plug.
Replacesparkplugor adjustgap_
Makenecesearyadjustments.
4,
5,
6.
Place throttlecontrolin "FAST" position.
Replace air cleaner cartridge.
Replace spark plug or adjust gap.
Drain fuet tank and refillwith fresh gasoline.
Make sure spark plugwire is seated properly on plug.
Make necessary adjuslments.
,,,],,,,,,,,,,,,,, ,,, ,,,,,],,,,,,,,,,,,,,,,,,,,,,,, ,,,,,,,,
1. Set depth stake for shallower tilling,
2. Replace air cleanercartridge.
8. Check oil level/change oil.
4, Clean and rogap or change spark plug,
5. Drain and clean fuel tank and refill, and clean
carburetor.
6. Drain fuel tank and refillwit_ fresh gasoline.
7. Drain fuel tank and carburetor, and refilltank with
fresh gasoline.
8. Remove fuel tank and clean.
9, Connectand tighten sparkp!ug wire.
10. Clean engine air screen
11. Clean!replace muffler.
12. Make necessan] adjustments.
13. Contact an authorized Sears Service Center Depart
ment.
ill ill illll i i i i ii
1. Check oil leve!/change oiL
2. Clean engine air screen.
3. Clean cylinder fins, air screen, and muffler area.
4. Remove and clean muffler.
5. Adjust carburetor to richer position.
t.
.....,,, .,,,,,,,,, .,,,.,_
Moisten ground or wait for more favorable soi!
conditions.
1. Wait for more favorable soil conditions.
i. Engage drive control.
2. lnspectladjust V-belt.
3. Inspect V-belt.
1, Shear pin(s) brokan.
.ill :_
1. Set depth stake for shallower tilling.
2. Check thret_e control set'ring.
5, Make necessary adjusttnenta,
1. Replace shear pin(s),
20