Owner`s manual

Your lawn mower hasbeenassembledat the fac-
tory except for' the grass catcher,.
The following parts are included - not assembled:
1 Grass Catcher' Top
1 Grass Catcher Bottom With Baffle
1 Grass Catcher Handle
1 Grass Catcher' Frame
1 Hardware Package
HOW TO S T-UP YOURLAWNMOWER
TO UNFOLDHANDLE
Remove handle padding holding operator presence
control bar to upper handle_
. Hold down operator presence control bar to up-
per handle to allow handle to move to mowing
position.
Raise handles until lower handle section locks in-
to place in mowing position (See Fig. 1).
o Raise upper handle section intoplace on lower
handle and tighten one (1) handle knob.
o Release operator presence controt bar' and
tighten remaining handle knob_
o Your lawn mower handle can be adjusted for your
mowing comfort. Refer to "Adjust Handle" in the
service and Adjustment Section of this manual_
TO ASSEMBLEGRASSCATCHER
SCREWS ACTUAL SIZE
1/4-20 x 3/4" #10-24 x 5/8" t/4-20 x 5/8"
SCREW SCREW SCREW
NOTE:The grass catcher for your lawn mower is sup-
lied unassemMedo To assemble your grass catcher
Ilow steps below_
o Place grass catcher frame into catcher top as
shown in Fig_ 2_
• Put one (1) #10-24 x 5/8 truss head screw into
hole in catcher top and catcher frame using
#10-24 locknuL DO NOT TIGHTEN (See Fig. 2).
o Put three (3) # 10-24 x 5/8 truss head screws into
the catcher frame using #10-24 iocknuts. Use a
medium phillips screwdriver to tighten screws
while holding the tocknut with an adjustable or
3/8 wrench (See Fig° 2)_
OPERATOR PRESENCE
CONTROL BAR
UPPER LIFT UP
UFT UP !?
LOWER ,NDLE
FIG. 1
TRUSS HEAD SCREWS
#10_24 x 5t8"
CLAMP
/
CATCHER TOP
# 10-24 CATCHER FRAME
FIG. 2
TOP HANDLE
,'--, t/4-20 x 5/8"
k PHILLIPS HEAD
SCREW
1/4-20 LOCKNUT "-'-_(_
FIG. 3