Owner`s manual

Y
TO ASSEmblE 6RASS CATCHER ICO_TID) .............................. _ ..................................... .................................................................................................................. _o:_
• Position round end of top handle into hole at rear
of handle recess (See Fig 3), The flat end of top
handle will fit into the square pocket at front of
handle recess° Put the I/4-20 x 5/8 screw through
the handle and catcher top, and install 1!4-20
Iocknut (See Fig. 3)_
o Use a medium phillips screwdriver to tighten
screw while holding the Iocknut with an adjustable
or 7116 wrench (See Fig_ 3)°
o Position top half of catcher on the bottom half ISee
Fig 4)° Align the holes in sides of top and bot-
tom halves of catcher°
o Instal) the right front truss head 114-20 x 3/4
screw through the catcher and install one (1) 1/4
keps nut on the screw. DO NOT TIGHTEN (See
Fig_ 4)_
• Install the other seven (7) screws and keps nuts,
• Use a medium phillips screwdriver to tighten the
screws while holding the keps nut with an ad-
justable or 7116 wrench_
NOTE: Check all screws and nuts to be sure they are
tight,
TO ATTACHGRASSCATCHER
° Lift rear door,
o Hold catcher by handle and place catcher frame
onto hinge bracket (See Fig_ 5)°
° Release rear door,
o When grass catcher is removed from lawn mower,
rear door doses for safety°
CAUTION: DONOT RUNYOUR LAWN MOWER !
° NEVER ATTEMPT TO OPERATE THE LAWN
MOWER WITH THE REAR DOOR REMOVED
OR PROPPED OPEN_
1/4-20 x 3f4"
CATCHER TOP TRUSS HEAD
SCREWS
CATCHER BOTTOM
START HERE
1 4 - 20 KEPS NUTS
FIG. 4
HINGE BRACKET
REAR DOOR OPEN
FIG. 5