Operator`s manual

SERVICE AN ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Flelease control bar.
, Make sure the blade and ali moving parts have completely stepped.
o Disconnect spark plug wire from spark ptug and place where it cannot come in contact with ptug,
LAWN MOWER
TO ADJUST CUTTING HEHGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual.
REAR DEFLECTOR
!
The rear deflector, attached between the rear wheels of
your lawn mower, is provided to minimize the possibility
that objects will be thrown out the rear of the lawn mower
into the operator's mowing position.
If the rear deflector becomes damaged, it should be
replaced_
TO REMOVE/REPLACE DRIVE BELT
(See Fig. 15)
. Remove drive cover, Remove belt by pushing down
on gear case pulley,
,, Turn lawn mower on its side with carburetor and fuel
cap up.
= Remove blade.
Remove debris shield.
o Remove belt from engine pulley on crankshaft.
, Install new belt by reversing above steps.
Always use factory approved belt to assure fit and
long life.
DRIVE
COVER
FiG. 15
___J
15