Operator`s manual

CE ADJUSTMENTS
TO ADJUST HANDLE (See Figs. 16 Thru 18)
Your lawn mower handle can be raised or lowered for your
mowing comfort. Four (4) positions are available: high,
medium high, medium low and low. Handles are shipped
mounted in the medium low position.
- To change from medium low to medium high position,
the upper and tower handle sections wiIl have to be
turned over (See Fig. 16B).
* Remove the controls and operator presence control
bar from the upper handle.
, Remove the starter rope guide from the lower handle.
- Remove hairpin cotters.
Disconnect the lower handle from the handle brackets
(See Fig. 18).
, Turr the handle over and reassemble the hairpin
cotters that have been removed.
- Reassemble the starter rope guide.
, Reassemble the controls and the operator presence
con_rot bar to the upper handle.
CAUTION: The operator presence
control bar must pivot freely to permit
blade brake engagement when control
bar is released. Do not over tighten the
fasteners holding the controls to the
upper handle,
• To change from medium ow to h gh position only the
upper handte section witl have to be turned over (See
Fig. 17A).
, To change from medium low to tow position, only the
lower handle section witl have to be turned over ',See
Fig. !7B).
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do not attempt
to increase engine speed or it may result in _ersonal
injury. If you believe that the engine ts running too fast or
too slow take your lawn mower to an authorized service
center for repair and adjustment.
CARBURETOR
Your carburetor has a non-adjustable fixed main jet for
mixture control. If your engine does not operate properly
due to suspected carburetor problems, take your lawn
mower to an authorized service center for repair and
adjustment.
SHIPPING POSITION
MEDIUM LOW
FIG. 16A
FIG. 17A
_, ,,,....... ,,
MEDIUM HIGH
FIG. 16B
LOW
\
FIG. 17B
SQUEEZE
TO REMOVE\
LOWER HANDLE
HANDLE
BRACKET
HAIRPIN CLIP
FIG, 18
16