Owner`s manual

I III II IIIII I
LAWNMOWERACCESSORIES
I I i III
These accessories were available when this lawn mower was produced. They are also available at most Sears
retail outlets, catalog and service centers. Most Sears stores can order repair parts for you, when you provide
the model number of your lawn mower. Some of these accessories may not apply to your lawn mower.
ENGINE
SPARKPLUG MUFFLER
©
II I IIIIII
AIR FILTER GASCAN ENGINEOIL
III I I
III
STABILIZER
LAWNMOWERMAINTENANCE
|l .i I i
BELT BLADE BLADEADAPTER WHEELS LAWNMOWERCOVER
IU III
I I IIIII I
ASSEMBLY
I IIII I [
Your lawn mower has been assembled at the fac-
tory except for the grass catcher bag and the grass
catcher frame.
TOREMOVELAWNMOWERFROMCARTON
• Cut down the corners of the carton and lay ends
and sides down.
• Cut the plastic wrapping and remove from over
handles and lawn mower.
• Remove loose parts if included with lawn mower,
(i.e. grass catcher, catcher frame, hardware pack,
etc.).
• Roll lawn mower out of carton and check carton
thoroughly for loose parts.
HOWTOSET-UPYOURLAWNMOWER
TO UNFOLD HANDLE
Remove any packing material from around control
bar.
• Raise lower handle section until it isin the upright
storage detents (See Figs. 1 & 2).
• Raise upper handle section until it is in-line with
lower handle and tighten one handle knob.
• Lower the entire handle assembly to the mowing
position and engage the height adjustment links
onto the handle bracket pins (See Fig. 2).
See "Adjust Handle" section, page 13 to select
the most comfortable mower handle position.
I I III III I I IIIIIIIIIIIII
IIII IIII II I
CONTROL BAR,,_ , "-,.
UPPER HANDLE_ /-/// _ ":" _'_
/, / _t
'"--.//// ! ,;." .._"
II/1 LOWER ,;/ ,,;,,
rV/// HANDLE ,_/ ,'/
HANDLE KNOB_ [_Y/ / m /,'.','_,_. /.',"
_r._ "_ ;._-"-- _ .. _.,.-'c'--"-_k.. .... "','," POSITION
I[ I II
FIG. I
II I
STORAGE
(L DETENTS
li ii I [ i
FIG. 2
II
I IIIII
IIIII
_JUIL