Manual

Y
FIGURE 7
/
ENGINE
- PULLEY
/
ATTACHMENTCLUTCH
SWITCH
POSITION)
HEIGHT ADJUSTMENT
KNOB
RGURE 9
REAR HINGE
_/ LiFT LEVER
PLUNGER
LIFT LEVER
LOWER
6. Mower and Drive Bell tnstal/at_n
iNSTALL MOWER PARALLEL LiNK
Yourtractor hasbeen shipped with the mower parallel link
includedin the parts carton. Install mower parallel link on
tractor (Fig. 7) usinghinge pin and retainerspring.
NOTE: SMALLER END OF PARALLEL LiNK MOUNTS
TO TRACTOR. USE THE SHORTEST HINGE PIN FOR
MOUNTING.
INSTALL MOWER
Your mower installs without the use of tools,
a. Raise attachement 1_ lever (Fig. 9) to its highest posi-
tion.
b. Turn height adjustment knob counterclockwise _ )
to lowest pos#ion (Fig. 10)
c, Slide mower under tractor with discharge guard to R.FL
side.
d. Install rear hinge pin through mower lift brackets and
parallel link (Fig, 8). Secure with retainer spring,
e, Move attachment lift lever (Fig. 9) forward to lower
suspension arms. Remove retainer springs from lift
trunnions (Fig, 8).
f, Slide trunnions through upper lift bracket holes and
secure with retainer springs (Fig, 8).
g. Pull L,H. idlerpulley (Fig. 12) toward the right hand side
of the tractor and roll be# over engine pulley (Fig. 8),
NOTE: MOWER DRIVE BELT iNSTALLATiON DECAL
LOCATED ON MOWER HOUSING.
h, Use attachment tilt lever (Fig 9) to raise mower.
L Turn height adjustment knob clockwise (f-_) to the
middle of its travel (Fig, 10),
7. Check Cutting Lever
Theblade housing was set at the factoryto cut leveL After mowing
a short distance, look at the area that was cut. ff the blade housing
cuts uneven, see "MOWER ADJUSTMENT, "page 21
8. Final Assembly
a, Make sure all fasteners are tight.
b, Read and follow the operation instructions (page 11).
Know the location and purpose of all controls.
c. Check oil and gasoline (page 12) before staffing the
tractor,
L.H, iDLER
NUT PULLEY
MOWER DRIVE
BELT
PULLEY
HEIGHT ADJUSTMENT
FIGURE 10 KNOB 10 RGURE 1"1