Manual

INSTALL SEAT
Adjust seat before tightening adjustment
knob.
I. Remove adjustment knob and flatwasher
securing seat to cardboard packing and
set aside for assembly of seat to tracton
2. Pivot seat upward and remove from the
cardboard packing, Remove the card-
board packing and discard.
3, Place seat on seat pan so head of shoul-
der bolt is positioned over large slotted
hole in pan_
4,, Push down on seat to engage shoulder
bolt in slot and pull seat towards rear of
tractor,
5. Pivotseatand panforward and assemble
adjustment knob and flat washer Iooselyr
Do not tighten,
6, Lower seat into operating position and
sit in seat,
7, Slide seat until a comfortable position is
reached which allows you to press cl utch/
brake pedal all the way down,
8, Get off seat without moving its adjusted
position,
9, Raise seat and tighten adjustment knob
securely,
Seat
/
Seat Pan-_
Shoulder
Bolt
CHECK BATTERY
1. Lift seat pan to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label
located between terminals) charge battery
for minimum of one hour at 6-10 amps, (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
Seat pan I
Label
Terminal
NOTE: You may now roll your tractor off
the skid, Follow the appropriate instruction
below to remove the tractor from the skid,
WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual° Be sure
tractor is in a well-ventilated area_ Be sure
the area in front of tractor is clear of other
people and objects,
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
I, Press lift lever plunger and raise attach-
ment lift lever to its highest position,
2_ Release parking brake by depressing
clutch/brake pedal,
3. Placegearshiftleverin neutral(N) position,
4. Roll tractor forward off skid,
5, Remove banding holding the deflector
shield up against tractor.
9