Owner`s manual
13 - ENG
Whentheair
compressor is operating, the check
valve is "open", allowing compressed
airtoentertheairtank.Whenthe
air compressor reaches "cut-out"
pressure, the check valve "closes",
allowing air pressure to remain inside
the air tank.
The motor has an automatic
reset thermal overload protector. If
the motor overheats for any reason,
the overload protector will shut off the
motor. The motor must be allowed to
cool down before restarting. The com-
pressor will automatically restart after
the motor cools.
Set the On/Off switch to "Off" .
instructions.
1. Set the On/Off switch to "Off".
2.
Plug the power cord into the
correct branch circuit receptacle.
(Refer to
Protection paragraph in
the Installation section of
this manual.)
3. Turn the regulator knob counter-
clockwise to set the outlet
pressure to zero.
4. Attach hose and accessories.
The hose or accessory will
require a quick connect plug if the air
outlet is equipped with a quick con-
nect socket.
Some air tools and accessories
accessories.
1.
Set the On/Off switch to "On"
and allow tank pressure to build.
Motor will stop when tank pressure
reaches "cut-out" pressure.
2. Turn regulator knob clockwise to
increase pressure and stop when
desired pressure is reached.
The compressor is ready for use.