User guide

AWARNING
USE OF A FACE
MASK ES
RECOMMENDED TO PREVENT EN-
HAU«-fON OF TOXEC MATERIAL.
2.
Horizorstal position
Vertical position
Turn fEuid control knob clockwise
until it stops, do not force. This
will shut off the fluid flow. NOTE:
The fluid or density of “tan spray”
is controlled by fluid control
knob.
3.
ACAUTION
first thread flush pattern
'^r ^Control
Knob
Ruid
^i^sponbol
Knob
4. Turn air valvo control knob
clockwise until it stops, do not
force.
Before Using Your Spray
Gun
1. Set up spray gun as described
in the "How to Set Up Spray
Gun" paragraph in the
“Assembly' section of this
manual.
To Use Spray Gun
1. The position of the air cap fioms
will deteimine the fan spray
pattern. Loosen air cap and rotate
horns to achieve desired pattern.
Tighten air cap.
ACAUTION
ACAUTION
Turn pattern conb'ol knob
counterclockwise until first thread
is flush with gun body. NOTE: Air
flow is controlled by pattern con
trol knob.
DO NOT turn pattern
control knob or fluid
control knob counter clockwise after
first thread is flush with the gun
body. They are under pressure vrtien
the gun is triggered and could leave
the gun wilb force.
ACAUTION
5. Adjust air pressure to 40 psi at
regulator.
DO NOT exceed 45
psi.
Pressure may vary
according to
viscosity of material used. Maximum
working pressure of gun is 45 psi.
DO NOT EXCEED PRESSURE LIMIT
OF GUN OR ANY OTHER COMPO
NENT IN SYSTEM!
6. Depress spray gun trigger and
gradually turn the fluid control
knob counterclockwise until
desired fluid flow is reached.
Trigger gun quickly, one second
on-off to test pattern.
NEVER point Spray
gun at self or any
other person. Accidental discharge
of material may result in serious
injury.
To adjust spray pattern and fluid
presaire:
• To adjust the fluid, turn fluid con
trol knob counterciockwise to in
crease or clockwise.
• To adjust the air flow, turn pattern
control knob counterclockwise to
increase or clockwise to de
crease.
• To fine tune the air flow, turn air
valve control knob counterclock
wise to increase, or clockwise to
decrease.
IMPORTANT: Always Clean gun after
each use. See 'Maintenance" section
for correct procedure.
9- ENG
D29783