Manual

7. Place assembled gun and wand on pressure
washer holder.
Pull the cord under the wire bracket to the
right of the wireloop.
Lift the pull cord handle up and slide the cord
to the left sliding the cord into the wire loop.
Next slide handle behind the wire bracket to
the left of the wire loop.
Engine recoilwill pullthe cord into its final
position.
8, Place pull cord intothewire bracket holder.
Pull the cord underthe wire bracket to the right
of the wire loop.
Checklist
Before going any further please reviewthe following:
• Be sure you have completed assembly instructions.
• Double check allfittings to be surethey are tight.
IMPORTANT: Before any attempt to start your pres-
sure washer be sure to check engine oil (See Opera-
tion underAdding EngineOil.)
Know Your High Pressure Washer
Read this Owner's Manual and Safety Rules before
operation of your High Pressure Washer Compare
this illustrationwith our pressurewasher to familiarize
yourselfwith the location of variouscontrolsand
adjustments. Save this manual for future reference.
PUMP- Develops high pressure.
PRESSURE REGULATOR- Allows you to adjust the
pressure of the outlet stream.
ENGINE RUN/STOP SWITCH- Sets engine in starting
mode for recoil starter -- Stops running engine.
RECOIL STARTER- Used for starting the engine
manually.
SPRAY GUN ASSEMBLY (Contains Gun and Wand)-
Controls the application of water onto cleaning surface
with trigger device.
OIL FILL- Port where engine oil is poured.
GAS TANKJCAP- Cap is removed and unleaded
gasoline is poured.
CHEMICAL INJECTION TUBE AND FILTER- Mixes
water and detergent in outlet water flow.
HIGH PRESSURE OUTLET- Connection for high pres-
sure hose.
CHOKE- Lever used for starting unit.
SPRAY GUN
ASSEMBLY HANDLE
HIGH PRESSURE
HOSE_
ENGINE
CHEMICAL
INJECTOR
TUBE & FILTER
HIGH
PRESSURE
OUTLET
WATER INLET
CONNECTION
RECOIL
OIL FILL
PUMP
7