Manual

Use clean, fresh, regular unleaded gasoline witha
minimumof 85 octane. Do not mix oil with gasoline. If
unleaded fuel is unavailable leaded fuel may be used.
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts such as
the carburetor,fuelfilter hose ortank duringstorage.
Also,experience indicatesthat alcohol-blendedfuels
(calledgasohol or usingethanolor methanol)can
attract moisture which leadsto separation and forma-
tion of acids duringstorage. Acidic gas can damage
the fuel system of an engine while in storage. To avoid
engine problems, the fuel system should be emptied
before storage of 30 days or longer.Never use engine
orcarburetor cleaner products inthe fueltank or
permanent damage may occur.
I_ CAUTION: Never start pressure washer without I
!
water source turned on and connected to
I
pressure washer. Failure to do so will cause
pump damage.
To Start Your Pressure Washer
• Remove gas cap.
• Add unleaded gasoline, slowly,to fuel tank.
• Do not overfill.
• Squeeze trigger on pressurewasher wand to relieve
airpressurecaused by turningon the water.Water
will spew out of the gun ina thin stream. This will
make it easierto start the engine.
• Engage the safety latch on the spray gun. This locks
the trigger in place and keeps you from accidentally
sprayinga highpressure stream.
SAFETY
.LATCH
• On the engine there is a choke/run lever. Place lever
to the choke position.
I "_..ml I o_1
• On the enginethere is a throttle control lever.Place
throttle to the rabbit position. Always start engine
with throttle in the rabbit (high speed) position.
• Connect garden hose to the water inletonthe
pressure washer. Tighten by turning counterclock-
wise.
PUMP
INLET
• Connect high pressure hoseto discharge on pump.
• Connect the garden hose to the water spout and turn
water supply on.
• Grasp the starter grip and pull slowly until resistance
isfelt,then pullfirmly to start engine.
NOTE: If enginedoes not start rightaway, squeeze the
triggeron the gun to relieve airpressurecaused by
turningon the water.Water will spew out of the gun ina
thin stream. This will make it easier to pullstart the
engine. If more than five pulls, place choke level back to
run position.
• When engine starts, gradually move choke lever to
RUN position.
• For hot engine restarts, make sure throttle is in the
rabbit (high speed) position and the choke lever is in
the RUN position.
• Grasp the starter grip and pull slowly until resistance
is felt, then pull firmly to start engine.