Product specifications

Immediately prepare your lawn mower for
storage at the end of the season or ifthe unit
will not be used for 30 days or more.
LAWNMOWER
When lawn mower is to be stored for a period
of time, dean it thoroughly,remove all dirt,
grease, leaves, etc. Store in a dean, dry area.
Clean entire lawn mower (See "CLEAN-
ING" in the Maintenance section of this
manual).
Lubricate as shown in the Maintenance
section of this manual.
Be sure that all nuts, belts, screws, and pins
are securely fastened. Inspect moving
pads for damage, breakage and wear.
Replace it necessary.
Touch up ail rusted or chipped peint
surfaces;sand lightlybefore painting.
HANDLE
You can fold your lawn mower handle for
storage,
Squeeze the bottom ends of the lower
handle toward each other until the lower
handle dears the handle bracket, then
move handle forward.
Loosen upper handle mounting belts
enough to allow upper handle to be folded
back.
IMPORTANT: When folding the handle for
storage or transportation,be sure to fold the
handle as shown or you any damage the
control cables.
When setting up your handle from the
storage position,the lower handle will
automatically lock into the mowing position.
Squeeze to_ld
/
Lower
handle
Handle
bracket
Operator presence control bar
\
Fold foward
for storage _
Lower
handle "_J"
Upper
,L_handle
,;;,
,_ Fold
_/_ backward
Mowing
position
ENGINE
FUEL SYSTEM
IMPORTANT: It is important toprevent gum
depos'_ from forming in essential fuel system
parts such as carburetor,f fuel filter,fuel hose
or tank during storage. Also, experience
indicates that alcohol blended fuels ( called
gasohol or using ethanol or methanol) can
attract moisture which leads to separation and
formation of acids during storage. Acidic gas
can damage the fuel system of an engine
while in storage.
Drain the fuel tank.
Start the engine and let it run untilthe fuel
lines and carburetor are empty.
Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
Use fresh fuel next season.
NOTE: Fuel sta_lizer is an acceptable
altemative in minimizing the formation of fuel
gum deposits during storage. Add stabilizer
to gasoline in fuel tank or storage container.
Always follow the mix ratio found on stabilizer
container. Run engine at least 10 minutes
after adding stabilizer to allow the stabilizer to
reach the carburetor. Do net drain the gas
tank and carburetor if using fuel stabilizer.
Hairpin
cotter
13