Operator`s manual

SWITCH LOCK
See Figure 4.
The switch trigger can be locked in the OFF position. This
feature can be used to prevent the possibility of accLdental
starting when not in use. To lockswitch trigger, place the
direction of rotation selector (Forward/Reverse Selector)
in center position.
SELECTOR WITH
CENTER LOCK POSITION
REVERSE
KEYLESS CHUCK
See Figure 5.
Your drill has a keyless chuck. Asthe nameimplies, you can
handtightenor releasedrillbits inthe chuckjaws. Graspand
holdthecollarofthechuckwithone hand.Rotatethechuck
body withyourotherhand.The arrows onthe chuck
indicatewhichdirectionto rotatethe chuckbodyinorderto
LOCK (tighten)or UNLOCK (release)the drillbit.
UNLOCK
DRILLBIT (RELEASE) CHUCKCOLLAR
FORWARD
SWITCH TRIGGER Fig. 4
_ WARNING: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
REVERSIBLE
See Figure 4.
This tool has the feature of being reversible.The direction
of rotation is controlled by a selector located above the
switch trigger. With the drill held in normal operating
position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The drilling
direction is reversed when the selector is to the right of
the switch. When the selector is in center position, the
switch trigger is locked.
_ CAUTION: To prevent gear damage, always allow
chuck to come to a complete stop before changing
the direction of rotation.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
CHUCKJAWS
LOCK
(TIGHTEN)
CHUCKBODY
Fig. 5
,_i WARNING: Do not hold chuck body with one hand
and use power of the drill to tighten chuck jaws on
drillbit. Chuck body couldslip inyour handor your
handcouldslip and come in contactwith rotating drill
bit.This could cause an accidentresultingin serious
personalinjury.
11