Operator`s manual

©©

Figure1.3

CONTENTS OF HARDWARE PACK

Hardware packed in carton

11,

Ref. No,

Hardware Description Qty.

Height Adjustment Handle (for handlebar) ........... 1

Keyed Washer (for height adjustment handle) ..... 1

Plastic Tie Strap ................................................... 4

Hairpin Cotter ....................................................... 3

3/8"-16 1" Hex Hd. Screw .................................... 2

3/8" Flat Washer .................................................. 2

3/8"-16 Nylok Lock Nuts ...................................... 2

Throttle Lever Knob ............................................. 1

#10-32 x 1/2" Round Hd. Screw .......................... 4

#10 Lockwasher ................................................... 4

#10-32 Nut ........................................................... 4

Wheel Gear Lever Knob ...................................... 1

5/16" Flat Washer .................................................. 1

T00LS/MATERIALS

NEEDED FOR ASSEMBLY

(1) * 3/8" open end wrench

(2) * 9/16" open end wrenches

(1) Scissors (to trim plasticties)

(1) Ruler

(1) Small Board (to tap plastic

knobs on control levers)

(1) Automotive-type air pressure

gauge

(1) Clean Oil Funnel

(1) Clean high-quality engine oil.

Refer to the assembly instruc-

tions in this manual for engine

oil specifications and quantity

required. Do not overfill.

• Adjustable wrenchesmay be used.

IMPORTANT: Motor oil must be

added to the engine crankcase be-

fore the engine is started. Follow the

instructionsin the "Operation" section.