Instruction manual

REPLACING THE LINE
Pre-wound spools offer the most con-
venient method for replacing line and
ensuring optimum performance.
* Replacement spools are color-
coded to ensure use of the correct
spool with your unit. Be sure to use
the same color spool as the existing
spool.
NOTE: Always clear dirt and debris
from cutting head components when
performing any type of maintenance.
* Hold spool and unscrew cap by turn-
ing in the direction shown on top of
the cap.
* Remove line guide ring and spool.
Use a pre-wound spool or refill spool
with line. If using a pre-wound spool,
remove tape strip from line and spool,
REFILLING THE SPOOL WITH LINE
_WARNING: Use only 0.065 inch
_.65 mm) diameter round line.
ther sizes and shapes of line will not
advance properly and will result in im-
proper cutting head function or can
cause serious injury. Do not use other
materials such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious _njury.
1. Cut a length of 25 feet of 0.065
inch (1.65 ram) diameter round
Craftsman® brand line.
Feed line in
direction
shown on
spool.
Spool
2. Insert one end of line into Centre
cavity of empty spool. Ensure line
will feed into spool in the direction
shown on the spool (counterclock-
wise).
3. Continue feeding line into spool,
leaving 4 - 6 inches (10 - 15 cm)
unwound from Centre of spool.
INSTALLING SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Replacement Spool
3. Rest guide ring on spool and place
line in slot. Allow line to extend
4 - 6 inches (10 - 15 cm) from
Centre of spool.
4. Ensure line remains in slot while
screwing cap on to the shaft.
Only tighten cap hand tightI
USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Spool with 0.065 inch Trimmer Line
Line Guide Ring
Cap Assembly
Assist Handle
Bolt Carriage, 1/4-20
Wing Nut
Shield Assembly
Edge Guide
PARTNUMBER
530403980
530403949
530403810
530403805
530403886
530016118
530403914
530403824
9