SEARS owner's manual Models C950-52474-7 4 H.P. 21 Inch CRAFTSMAN® DUAL STAGE SNOWBLOWER C950-52475-7 5 H.P. 23 Inch C950-52677-7 8 H.P. 25 Inch • Assembly • Operating Instructions • Replacement Parts • Warranty CAUTION: You must read and understand this owner's manual before operating unito Serial No. SEARS litho in Canada _ CANADA INC., TORONTO, Part No. 7524 ONTARIO M5B 288 Issue 5/87A .
engine to warm up for a few minutes as the engine will not develop full power until it reaches operating temperature. AOANGERA Gasoline is flammable and caution must be used when handling or storing il. Do not fili fuel tank while snowblower is running, hot, or when snowblower Is in an enclosed area. Keep away from open flame, electrical spark, and DO NOT SMOKE while filling the fuel tank.
2. With engine not running wipe ali snow and moisture fram carburetor cover (Figure 10) in area of contrai levers. Also move controllevers backward and forward several times. 2. Move Throttle Control (UP) to "Fast" position. Insert key into ignition slot. Be sure it snaps into piace. (Figure 11). Do not turn key. 3. Rotate CHOKE knob to "OFF" IMPORTANT: After each use of the snowblower, stop the engine, remove the ignition key, remove ali accumulated snow tram the snowblower and wipe clean.
NOTE: THIS ELECTRIC ST ARTER IS THERMALLV PROTECTEO. IF OVERHEATED IT WILL STOP AUTOMATICALL V, ANO CAN BE REST ARTEO ONL V WHEN IT HAS COOLEO TO A SAFE TEMPERATURE. (A WAIT OF ABOUT 5 TO 10 MINUTES IS REQUIREO:j 6. START ENGINE: A. Push ST ARTER BUTTON (Figure 11A) to engage starter rnotor and crank engine. B. Move CHOKE on engine to "Full" ing engine. NOTE: THIS ELECTRIC ST ARTER IS THERMALL V PROTECTEO.
ìì Snowblower Operation 6. Engage traction drive clutch lever (Ieft hand). As the snowblower starts to move, maintain a firm hold on the handles and guide the snowblower along the cutting path. Do not attempt to push the snowblower. The most effective use of the snowblower will be established by experience, taking into consideration the terrain, wind conditions and building location which will determine the diraction of the discharge chute.