Owners manual

ASSEMBLY – DOORS

SHED ASSEMBLY – HEADERS

Place front header (K) over door opening and ﬁt the

two protruding support legs on left and right front

corners into pockets molded in front header. Tabs on

front header must be seated in header channel pocket.

Secure front header using two screws (BB).

Note: DO NOT leave front header unsupported until

Ridge Beam (O) is secured (Step 23)

Place rear header (L) over back walls and ﬁt the two

protruding support legs on left and right back corners

into pockets molded in rear header. Tabs on rear header

must be seated in header channel pocket. Secure

front header using eight screws (BB). Note: DO NOT

leave front header unsupported until Ridge Beam (O) is

secured (Step 22)