Owners manual

21
1
3
1
2
12
FF
AA
MM
LL
1
1
3
2
11
LL
MM
x2x2
x2
x2
x2
EE
EE
AA
AA
Attach side adaptor bracket (FF) or full length side adapter
bracket (ZZ) at end of left truss leg (AA) with one cap screw
(MM) and one nut (LL). Repeat for remaining side adaptor
bracket (FF).
Note: DO NOT over tighten. This makes roof assembly difficult.
Attach two truss cross beams (EE) to two truss legs (AA) with
two hex bolts (MM) and two nuts (LL). Stand truss and check
cross beam is level.
Repeat steps 11-13 twice for
65007 expansion
(2 expansion kits).
Repeat steps 11-13 three times for
65007 expansion
(3 expansion kits).
TRUSS PRE – ASSEMBLY
Place skylight gasket (YY) into skylight (HH). Place skylight
(HH) onto right roof panel (O). Secure from underside with
eight screws (JJ). Make sure rib on plastic parts is seated fully
against gasket on skylight. Repeat for remaining roof panels.
2
3
1
13
x8
HH
HH
YY
JJ
O