Owners manual

24
Tip left front corner (E) back to vertical position and align lower
tabs on right side with slots in floor.
Note: You will hear a snap when tab is fully engaged.
1
2
20
A
E
1
2
22
F
A
E
Side viewSide view
Top viewTop view
Before proceeding, make sure
corner is square (top view) where it
meets the floor and that panel is flush
(side view) with floor.
If not, repeat Steps 18–20
until square and flush.
21
23
NN
F
x4
Secure side panel (F) with four Easy Bolts (NN), working from
floor to roof. DO NOT use torque wrench. Use Easy Bolt easy
driver (OO) and hand tighten. Easy Bolt head will be flush when
fully seated. DO NOT over tighten Easy Bolts.
Note: You may hear a click when Easy Bolt has been tightened
completely.
Align tabs on bottom of side panel (F) with slots along
floor (A). Lower panel into slots and lock in place by sliding
panel toward front corner.
Note: Use a rubber mallet to “push” side panel (F) into
locked position.
Assembly–Walls (continued)