Instruction Manual
ENGLISH
12
Accessories
WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Sharpening the blade twice during a mowing season is
usually sufficient under normal circumstances. Sand causes
the blade to dull quickly. If your lawn has sandy soil, more
frequent sharpening may berequired. REPLACE BENT OR
DAMAGED BLADEIMMEDIATELY.
When Sharpening the Blade:
• Make sure blade remainsbalanced.
• Sharpen blade at the original cuttingangle.
• Sharpen cutting edges on both ends of blade, removing
equal amounts of material from bothends.
To Sharpen Blade in a Vise (Fig. M)
1. Be sure the bail handle is released, the blade has
stopped and safety key and battery pack are removed
before removing theblade.
2. Remove blade from mower. See instructions for
Removing and InstallingBlade.
3. Secure blade
29
in a vise
32
.
4. Wear proper eye protection and gloves and be careful
not to cutyourself.
5. Carefully file the cutting edges of the blade with a fine
tooth file
33
or sharpening stone, maintaining the
angle of the original cuttingedge.
6. Check balance of blade. See instructions for
BladeBalancing.
7. Replace blade on mower and tightensecurely.
Fig. M
32
29
33
Blade Balancing (Fig. N)
Check balance of the blade
29
by placing center hole in
the blade over a nail or round screwdriver
34
, clamped
horizontally in a vise
32
. If either end of the blade rotates
downward, file along the sharp edge of that dropping end.
Blade is properly balanced when neither enddrops.
Fig. N
29
32
34
Lubrication
No lubrication is necessary. Do not oil the wheels. They have
plastic bearing surfaces which require nolubrication.
Cleaning (Fig. A)
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always use ANSI Z87.1 (CAN/CSA Z94.3)
approved eye protection and NIOSH/OSHA/MSHA
approved respiratory protection when performingthis.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into aliquid.
Release bail handle
5
to turn mower off, let the blade come
to a stop and then remove battery and safety key. Clean
out any clippings which may have accumulated on the
underside of the deck. After several uses, check all exposed
fasteners fortightness.
Corrosion (Fig. A)
Fertilizers and other garden chemicals contain agents which
greatly accelerate the corrosion of metals. If you mow in
areas where fertilizers or chemicals have been used, the
mower should be cleaned immediately afterward as follows:
Release bail handle
5
to turn mower off and remove
battery and safety key. Wipe all exposed parts with a
dampcloth.
CAUTION: Do not pour or spray water on the mower
in an attempt to clean IT. Do not store the tool on or
adjacent to fertilizers or chemicals. Such storage can
cause rapidcorrosion.
Meets CPSC Safety Requirements
CRAFTSMAN Mowers conform to the safety standards of
the American National Standards Institute, and the U.S.
Consumer Product Safety Commission. The blade turns
when the blade motor isrunning.