Operating Guide

7
ENGLISH
Blower Mode (Fig. L)

CAUTION: Always wear safety glasses.
Wear a filter mask if the operation is dusty. Use
of gloves, long pants and substantial footwear is
recommended. Keep long hair and loose clothing
away from openings and moving parts. THIS BLOWER
IS FOR HOUSEHOLD USEONLY.
NOTE: Ensure the blower is switched off and disconnected
from the power supply before attaching or removing the
blower tubes.
The blower tube must be assembled to the housing
beforeuse.
• Hold the blower with both hands as shown in Fig.L
and sweep from side to side with the nozzle several
inches above the surface. Slowly advance keeping the
accumulated pile of debris in front ofyou.
Fig.L
in place. Never reach down into housing through
tubehole.
3. Unlatch the fan cover
14
from the bottom of the power
head. Refer to Figure G for further instruction.
4. Attach the vacuum tube assembly to the power head
(Fig. H) by locating the assembly as indicated by arrow,
then pivot about this point until the locking/release
catch is fully engaged and an audible click is heard.

CAUTION: CUT HAZARD. Ensure the
vacuum tube assembly is securely seated and latched
intoposition.
5. Unzip the collection bag
8
.
6. Connect the cord on the power head to the power supply.
7. Position the tube slightly above the debris/leaves. Turn
the blower/vac on, then using a sweeping motion the
debris/leaves will be sucked up the tube, mulched and
deposited into the collection bag (Fig. M) .
8. As the collection bag fills, the suction power will
decrease. Turn the blower/vac off and unplug from
power supply before emptying collectionbag.
Fig. M
Emptying Back Pack Collection Bag (Fig. N)

CAUTION: NEVER REMOVE THE
COLLECTION BAG WITHOUT FIRST TURNING OFF AND
UNPLUGGING THEVACUUM.
1. Empty the back pack collection bag
8
by unzipping the
bag zipper.
Fig. N
8
Vacuum Mode (Fig. A, G, I, M)

WARNING: Ensure product is switched off
and disconnected from the powersupply.
To fit the backpack collection bag assembly to product:
1. Remove blowtube.
2. Push the flexible collection tube assembly
12
onto the
power head
2
until it is in the fully locked position and
an audible click is heard. (Fig. I).

WARNING: Do not operate blower
without blow tube or flexible collection tube securely
Fig.K
1