Operating Guide

12
5. (Figure U) Keep all cutter lengths
equal.
6. If damage is present on the chrome
surface of the top plates or side
plates, file back until such damage is
removed.
CAUTION: After filing, the cutter will
be sharp, use extra caution during this
process.
NOTE: Each time the chain is sharpened,
it loses some of the low kickback qualities
and extra caution should be used. It is
recommended that a chain be sharpened no
more than four times.
ACCESSORIES
WARNING: The use of accessories
not recommended in this manual may be
hazardous.
Accessories are available from your local
retailer.
• Replace bar with a corresponding 16-inch
low-kickback bar.
NOTE: Ensure the new bar is equipped with
a tool-free tension assembly (16).
This Class B digital apparatus complies with
Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television reception,
U
which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user’s
authority to operate the equipment. This
Class B digital apparatus complies with
Canadian ICES-003.
Three Year Limited Warranty
CRAFTSMAN will repair or replace, without charge,
any defects due to faulty materials or workmanship
for three years from the date of purchase. This
warranty does not cover part failure due to normal
wear or tool abuse. For further detail of warranty
coverage and warranty repair information, visit
www.craftsman.com or call
1-888-331-4569. This warranty does not apply
to accessories or damage caused where repairs
have been made or attempted by others. THIS
LIMITED WARRANTY IS GIVEN IN LIEU OF ALL
OTHERS, INCLUDING THE IMPLIED WARRANTY
OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, AND EXCLUDES ALL
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Some states do not allow limitations on how
long an implied warranty lasts or the exclusion or
limitation of incidental or consequential damages,
so these limitations may not apply to you. This
warranty gives you specific legal rights and you
may have other rights which vary in certain states
or provinces.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the
performance of your CRAFTSMAN Power Tool or
Nailer for any reason, you can return it within 90
days from the date of purchase with a receipt for a
full refund – no questions asked.
LATIN AMERICA: This warranty does not apply
to products sold in Latin America. For products
sold in Latin America, see country specific
warranty information contained in the packaging,
call the local company or see website for
warranty information.
FREE WARNING LABEL REPLACEMENT:
If your warning labels become illegible or
are missing, call 1-888-331-4569 for a
free replacement.