Instruction Manual

7
ENGLISH
Adjusting Depth (Fig. G)

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove air supply before
making any adjustments or removing/installing
attachments or accessories. An accidental
actuation can causeinjury.
The depth that the fastener is driven can be adjusted using
the depth adjustment wheel next to the trigger of the tool.
1. To drive the fastener shallower, rotate the depth
adjustment wheel
8
to the right.
2. To drive a fastener deeper, rotate the depth adjustment
wheel
8
to the left.
8
Fig.G
Clearing a Jammed Fastener (Fig. A, H, I)

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove air supply before
making any adjustments or removing/installing
attachments or accessories. An accidental
actuation can causeinjury.
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
toclear:
1. Disconnect the tool from the air supply.
2. Release magazine release lever
6
from behind nails.
3. Push down jam clearing latch
9
then pull up to open
front door
14
.
4. Remove bent nail, using pliers if necessary.
5. If driver blade is in the down position, insert screwdriver
or other rod into nosepiece and push driver blade back
in position.
6. Remove rod and close front door.
7. Lift latch to secure door to nosepiece.
8. Reinsert nails into magazine (refer to Loading Fasteners).
9. Release magazine release lever
6
.
10. Reattach air supply.
9
Fig.H
Fig.I
14
NOTE: Should nails continue to jam frequently in nosepiece,
have tool serviced by an authorized service center.
Cold Weather Operation

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove air supply before
making any adjustments or removing/installing
attachments or accessories. An accidental
actuation can causeinjury.

WARNING: Do not store tools in a cold weather
environment to prevent frost or ice formation on the
tools operating valves and mechanisms that could
cause toolfailure.

WARNING: Some commercial air line drying
liquids are harmful to “O”‑rings and seals – do
not use these low temperature air dryers without
checkingcompatibility.
When operating tools at temperatures below freezing:
1. Make sure compressor tanks have been properly
drained prior touse.
2. Keep tool as warm as possible prior touse.
3. Make certain all fasteners have been removed
frommagazine.
4. Lower air pressure to 80 p.s.i.g. (5.7 kg/cm
2
) orless.
5. Reconnect air and and load nails intomagazine.