Use And Care Manual

3
TOOLS REQUIRED:
3/8-in. Wrench Electric Drill
1/2-in. Socket 5/32-in. Drill Bit
Cross-tip Screwdriver
NOTE: Not all assembly instructions will relate to your model.
SIDE HANDLE ATTACHMENT
Items Needed:
#14 - 10 x 3/4 Cross-tip Screw (Qty: 4)
Cross-tip Screwdriver
Process:
• Attach the side handle using (4) #14 - 10 x 3/4
Cross-tip screws.
• Hand tighten. Do not overtighten.
HARDWARE
#14 - 10 x 3/4 Cross-tip Screw
(Qty: 4)
#14 - 10 x 5/8-in Hex Screws
(Qty: 16)
HARDWARE INCLUDED:
26-INCH CABINET HARDWARE
CASTER INSTALLATION (26 INCH)
Items Needed:
#14 - 10 x 5/8-in Hex Screws (Qty: 16)
3/8-in Wrench
Process:
NOTE: Use adequate personnel for this operation.
NOTE: Failure to install caster angles may result in
premature cabinet failure.
• Lay the cabinet down on its back. Use packaging
materialtoprotectthepaintnish.
• Mount both swivel casters on the same side of the
cabinet as the side handle.
• Attach casters using (4) #14 - 10 x 5/8 Hex Screws for
each caster.
• Wrench tighten all screws. Do not overtighten.
• Return the unit to its upright position.
ASSEMBLY
LABELS (IF APPLICABLE)
Process:
NOTE: Make sure the surface you are applying
the label to is free of debris or other labels before
beginning application.
• Applyalightlmofglasscleanertothesurfacewhere
the label is to be applied.
• Peel the label from the backing and place the label in
position.
• Check alignment of the label and adjust accordingly.
• Hold the label in position and squeegee off excess liquid
with a towel, working from the center toward each end of
the label.
• Suggested label location is shown.