Assembly Instructions

4
Items Needed:
1/4-20 x 1/2" Carriage Bolt (Qty: 10)
5/16" Washer (Qty: 10)
1/4-20 Serrated Flange Nut (Qty: 10)
Side Panel
Rail
Note: Drawer kit may be installed on left or right side of
workbench. Installation is shown on right side.
Process:
• Leansidepanelatanangletotundertherailsonthe
workbench.
• Line up the side panel with notches on the top rails of
the workbench. Rotate side panel to the upright position
inside notches.
• Attach side panel using (6) bolts, (6) washers, and (6)
nuts.
• Attach rail, as shown, using (4) bolts, (4) washers, and
(4) nuts.
• Adjust bench to desired height. (See operation section;
Leveling foot adjustment.)
Items Needed:
#8 - 32 x 3/8" Truss Head Screw (Qty: 16)
#8 - 32 Keps Nut (Qty: 16)
Slide (8)
Process:
• Separate slide parts. (See drawer removal instructions.)
• Attach (2) drawer slides (Fd) to each drawer as shown.
• Wrench tighten.
Workbench top
removed for clarity
Sidepaneltsin
workbench rail
Side
Panel
Rail
Fd
Fu
Release
Drawer
#8 - 32 x 3/8”
Truss Head
Screw
#8 - 32
Keps Nut
Fd
1/4-20 Serrated
Flange Nut
5/16” Washer
1/4-20 x 1/2”
Carriage Bolt