Instruction Manual

PROGRAMMING
Your garage door opener has been programmed at the factory to operate with your remote control. Older accessories are not compatible, see page 43 for compatible
accessories. Programming can be done through the door control or the learn button on the garage door opener. To program additional remote controls refer to the
instructions provided with the additional remote controls.
IMPORTANT NOTE: If your vehicle is equipped with a Homelink
®
, you may require an external adapter depending on the make, model and year of your vehicle. Visit
www.homelink.com for additional information.
PROGRAM A REMOTE USING THE LEARN BUTTON
1. Press and release the Learn button on the
garage door opener. The Learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the button
on the remote control.
3. Release the button when the garage door
opener light blinks. It has learned the code. If
light bulbs are not installed, two clicks will be
heard.
When replacing the light lens cover, ensure the antenna wires are hanging straight
down.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL OR KEYLESS ENTRY PIN
USING THE MULTI-FUNCTION CONTROL PANEL
PIN
? ? ? ?
OR
The command LED
will flash once.
The command LED
will flash once again.
1. Press the LEARN button on the door
control to enter Programming Mode.
2. Press the LEARN button again, the LED
will flash once.
3. Press the button on the remote control
that you wish to operate your garage door.
OR
Enter a 4-digit personal identification
number (PIN) of your choice on the
keyless entry keypad. Then press the
ENTER button.
The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
Repeat the steps above for programming additional
remote controls or keyless entry devices.
36