Instruction Manual

PLANNING (CONTINUED)
ONE-PIECE DOOR INSTALLATIONS
l Generally, a one-piece door does not require reinforcement. If your door is
lightweight, refer to the information relating to sectional doors in
Installation Step 8.
l Depending on your door’s construction, you may need additional mounting
hardware for the door bracket (Installation Step 8).
Without a properly installed safety reversing sensor, persons (particularly small
children) could be SERIOUSLY INJURED or KILLED by a closing garage door.
l The gap between the bottom of the garage door and the floor MUST NOT
exceed 1/4" (6 mm). Otherwise, the safety reversal system may NOT work
properly.
l The floor or the garage door MUST be repaired to eliminate the gap.
Safety Reversing
Sensor
Access
Door
FINISHED CEILING
Support bracket
& fastening
hardware is required.
See page 16.
Safety Reversing
Sensor
Header Wall
Gap between floor
and bottom of door must
not exceed 1/4" (6 mm).
Wall-Mounted
Door Control
Rail
Motor Unit
Header
Wall
Header
Bracket
Trolley
Straight
Door
Arm
Emergency
Release
Rope & Handle
Door Bracket
Curved
Door
Arm
Garage
Door
Rail Tab
Belt
Rail
CLOSED POSITION
Access
Door
Safety
Reversing Sensor
Safety
Reversing Sensor
Gap between floor
and bottom of door
must not exceed
1/4" (6 mm).
Garage
Door
Header
Wall
Header
Bracket
Door
Bracket
Straight
Door
Arm
Curved
Door Arm
Trolley
Emergency
Release
Rope &
Handle
Rail
Belt
Rail Tab
CLOSED POSITION
ONE-PIECE DOOR WITHOUT TRACK
ONE-PIECE DOOR WITH TRACK
6