How to Guide
Table Of Contents
- English (United States)
- INTRODUCTION
- INSTALLATION
- ADJUSTMENT
- myQ® SMARTPHONE CONTROL
- OPERATION
- TROUBLESHOOTING
- REPAIR PARTS
- Accessories
- Warranty
- Automatic Garage Door Opener Safety & Maintenance Guide
- Repair Parts and Service
- Español (México)
- INTRODUCCIÓN
- Revisión de los símbolos y términos de seguridad
- Operación en estado pasivo
- Preparación de la puerta de garaje
- Pruebe la intensidad de la señal de Wi-Fi® en el garaje.
- Herramientas necesarias
- Planificación
- Contenido de la caja
- Inventario de herrajes
- ENSAMBLAJE PASO 1
- Ensamblaje Paso 2
- ensamblaje paso 3
- Ensamblaje paso 4
- Ensamblaje paso 5
- Ensamblaje paso 6
- INSTALACIÓN
- AJUSTES
- CONTROL myQ® PARA TELÉFONOS INTELIGENTES
- FUNCIONAMIENTO
- RESOLUCIÓN DE PROBLEMAS
- Piezas de repuesto
- Accesorios
- Garantía
- Guía de seguridad y mantenimiento del abre-puertas de garaje automático
- Piezas de repuesto y servicio
- INTRODUCCIÓN
ADJUSTMENT
INTRODUCTION
Your garage door opener is designed with electronic controls to make setup and
adjustments easy. The adjustments allow you to program where the door will stop
in the open (UP) and close (DOWN) position. The electronic controls sense the
amount of force required to open and close the door. The force is adjusted
automatically when you program the travel.
NOTE: If anything interferes with the door’s upward travel it will stop. If anything
interferes with the door’s downward travel, it will reverse.
UP (Open)
DOWN (Close)
ONE-PIECE DOORS ONLY
When setting the UP travel for a one-piece door ensure that the door does not slant
backwards when fully open (UP). If the door is slanted backwards this will cause
unnecessary bucking and/or jerking when the door is opening or closing.
PROGRAMMING BUTTONS
The programming buttons are located on the left side panel of the garage door
opener and are used to program the travel.
Without a properly installed safety reversal system, persons (particularly
small children) could be SERIOUSLY INJURED or KILLED by a closing garage
door.
l Incorrect adjustment of garage door travel limits will interfere with proper
operation of safety reversal system.
l After ANY adjustments are made, the safety reversal system MUST be
tested. Door MUST reverse on contact with 1-1/2" (3.8 cm) high object (or
2x4 laid flat) on floor.
To prevent damage to vehicles, be sure fully open door provides adequate
clearance.
UP
Button
Adjustment
Button
DOWN
Button
CORRECT
INCORRECT
PROGRAMMING BUTTONS
29