How to Guide

REMOTE CONTROL AND WIRELESS KEYPAD
Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below.
PROGRAM USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that you wish to
operate your garage door.
Wireless Keypad: Enter a 4-digit personal identification number (PIN) of your
choice on the wireless keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code
has been programmed.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
3
TO ERASE THE MEMORY
ERASE ALL REMOTE CONTROLS AND WIRELESS KEYPADS
1. Press and hold the LEARN button on garage door opener until the learn LED
goes out (approximately 6 seconds). All remote control and wireless keypad
codes are now erased. Reprogram any accessory you wish to use.
ERASE ALL DEVICES (INCLUDING myQ
®
ENABLED ACCESSORIES)
1. Press and hold the LEARN button on garage door opener until the learn LED
goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the learn LED goes
out. All codes are now erased. Reprogram any accessory you wish to use.
ERASE THE CONNECTION FROM GARAGE DOOR OPENER TO HOME Wi-Fi
NETWORK
1. Press and hold the black adjustment button on the garage door opener until 3
beeps are heard (Approximately 6 seconds).
37