Warranty Guide

8
OPERATION
Operation
Starting & Stopping the Engine
Refer to the Engine Operator’s Manual for instructions on starting and stopping the engine.
Adjusting the Blower Direction
The air flow can be directed to one of three directions using the blower direction lever to move
the louvers.
WARNING
Exercise caution when operating blower. Do not allow the directional discharge chute to
point in the direction of bystanders or pets.
NOTE: The blower direction lever must be in the middle position when operating the blower with
the chute attachment to keep it locked in place.
1. Pull the lever out and away from the blower. See Figure 3.
2
Side view
Louvers
Blower Direction
Lever
1
Figure 3
2. Move the lever to the left to direct airflow downward or to the right to direct airflow upward.
See side view in Figure 3.
3. Release lever towards blower, making sure it secures into place.
Attaching the Chute Attachment
WARNING
DO NOT operate without shields and guards in place.
To redirect airflow at a 90° angle during operation, a chute attachment is included with your jet sweep
blower.
1. Pivot the blower direction lever all the way to the right, into the highest position. See Figure 4.
2
1
3
Figure 4
2. Slide the chute attachment downward, over the opening.
3. Pivot the direction lever to the middle position to lock the chute attachment in
place. See Figure 4.
WARNING
Keep hands out of inlet and discharge openings while machine is running.
There are rotating blades inside.