Owner`s manual

A CAUTION: Wipeoff anyspilled oil or
fuel. Do notstore, spill or usegasoline
near an open flame.
CAUTION: Alcohol blendedfuels
(calledgasoholor usingethanol or metha-
nol) can attract moisturewhich leads to
separationand formation of acids during
storage. Acidic gas candamage the fuel
system of an enginewhile instorage. To
avoid engine problems,the fuel system
shouldbe emptied before storage of 30
days or longer. Emptythe gas tank, start
the engine and let it run until the fuel lines
and carburetorare empty. Use fresh fuel
next season. See Storage Instructionsfor
additionalinformation. Never use engine
or carburetorcleaner productsinthe fuel
tank or permanentdamagemay occur.
TO STOP ENGINE
• To stop engine, release operator pres-
ence control bar.
TO START ENGINE
NOTE: Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the product
and should be considered normal.
1. To start a cold engine, push primer
three (3) times before trying to start.
Use a firm push. This step is not usu-
ally necessary when starting an engine
which has already run for a few minutes.
2. Hold operator presence control bar
down to the handle and pull starter
handle quickly. Do not allow starter rope
to snap back.
NOTE: In cooler weather it may be neces-
sary to repeat priming steps. In warmer
weather over priming may cause flooding
and engine will not start. If you do flood
engine, wait a few minutes before attempt-
ing to start and do not repeat priming
steps.
MOWING TIPS
4& CAUTION: Do not use de-thatcher
blade attachments on your mower. Such
attachments are hazardous, will damage
your mower and could void your warranty.
• Under certain conditions, such as very
tall grass, it may be necessary to raise
the height of cut to reduce pushing effort
and to keep from overloading the engine
and leaving clumps of grass clippings.
It may also be necessary to reduce
ground speed and/or run the lawn
mower over the area a second time.
• For extremely heavy cutting, reduce the
width of cut by overlapping previously
cut path and mow slowly.
• For better grass bagging and most cut-
ting conditions, the engine speed should
be set in the FAST position.
• For side discharge lawn mowers, cutting
in a counter-clockwise direction, start-
ing at the outside of the area to be cut,
spreads grass clippings more evenly
and puts less load on the engine. To
keep clippings off of walkways, flower
beds, etc., make the first cuts in a clock-
wise direction.
• Pores in cloth grass catchers can
become filled with dirt and dust with use
and catchers will collect less grass. To
prevent this, regularly hose catcher off
with water and let dry before using.
• Keep top of engine around starter clear
and clean of grass clippings and chaff.
This will help engine air flow and extend
engine life.