Owner's Manual

4
Call1-866-576-8388formissingpartsorassemblyhelp
DONOTRETURNTOSTORE
STEP 5: (SEE FIGURE 6)
Spreadendsofbumperenoughtotslotsontobolts •
in rear mounting holes in tractor frame.
Thebumperhasthreemountingholes.Therear •
hole provides the most clearance while the forward
holesprovideaneaterappearance.Useahole
that provides enough clearance for hood to stay in
raisedpositionwhenopened.Insertacarriagebolt
and washer through tractor frame and into desired
mountingholeoneachsideofbumperandsecure
withawhizlocknut.
IMPORTANT: Beforefullytighteningnuts,besure
tractor hood will stay in raised position when opened.
CARRIAGE BOLT
AND WASHER
WHIZLOCK NUT
FIGURE 6
STEP 4: (SEE FIGURE 5)
Insertacarriageboltintothesecondmountinghole •
from the front of the tractor frame and fully tighten a
whizlocknutontothebolt.Repeatonothersideof
tractor.
WHIZLOCK
NUT
CARRIAGE BOLT
AND WASHER
FIGURE 5
STEP 3: (SEE FIGURE 4)
Placeplugonaworkbenchorsolidtableandpush •
endofbumperdownontoplug.Repeatforallplugs.
FIGURE 4
PLUG
SHORT STEP
BUMPER
PUSH DOWN
WITH EVEN
PRESSURE
WORK BENCH
OR SOLID TABLE
STEP 2: (SEE FIGURE 3)
Removetractorhood.(Refertotractormanual.) •
Removethebrowningshieldasshown. •
FIGURE 3
REMOVE
BROWNING SHIELD
REMOVE
FRONT SCREWS