Owner's Manual

7
7
Call1-866-576-8388formissingpartsorassemblyhelp
DONOTRETURNTOSTORE
SUSPENSION BRACKET
REMOVE BOLT
IF PRESENT
INSTALL (C), (D) IF
HOLE IS EMPTY
EXHAUST TUBES
BROWNING SHIELD
MUFFLER
REMOVE BOLT
IF PRESENT
INSTALL (C) (D)
IF HOLE IS EMPTY
SUSPENSION BRACKET
(LT) LAWN TRACTOR
(GT) GARDEN TRACTOR
SUSPENSION
BRACKET
REMOVE BOLT
IF PRESENT
INSTALL (C), (D) IF
HOLE IS EMPTY
(LT) LAWN TRACTOR
FIGURE 5
STEP 4: (SEE FIGURE 5)
Removeanyboltspresentin • front mounting holes in
sideoftractorframe.Ifboltwillnotscrewoutofhole,
checkifanutispresentonboltoninsideofframe.
OnGTtractors,ifaccesstonutisblockedbyafront
mountedmufer,slidemuferdownexhausttubesto
restontopofbrowningshield.
IMPORTANT: Be sure to re-attachmuferandheat
shieldafterbumperisinstalled.
If • rear mounting holes in tractor frame are empty,
installhexboltsandwhizlocknutssuppliedinthe
partsbags.Seegure5.
STEP 5: (SEE FIGURE 6)
• Spreadendsofbumperenoughtotslotsontobolts
in rear mounting holes in tractor frame.
• Thebumperhasthreemountingholes.Therear
hole provides the most clearance while the forward
holesprovideaneaterappearance.Useahole
that provides enough clearance for hood to stay in
raisedpositionwhenopened.Attachthebumper
usingeitherstandardhexboltsandwhizlocknutsor
selfthreadingboltsandlockwashers.Usetheself
threadingboltsifstandardhexboltsdonotinsert
freely into the hole in the tractor frame.
IMPORTANT: Before fullytighteningbolts,besure
tractor hood will stay in raised position when opened.
FIGURE 6
BOLT (A) or (B)
LOCKWASHER (E)
FOR BOLT (A)
WHIZLOCK NUT (D)
FOR BOLT (B)
LAWN TRACTOR (LT) SHOWN