Owner`s manual

SERVmC
i, i i, ii ,, i,,,i ,,,i.........................................
TRANSAXLE SHIFTER LINKAGE AND AD-
JUSTMENT (See Figs. 30 and 31)
The transaxle should be in neutral when the gear shift lever
is in the neutral (N) (lock gate) position The adjustment is
preset at the factory; however, if adjustment is needed,
proceed as follows:
° Make sure transaxte is in neutral (N),
• Loosen two Iocknuts on tie rod.
, Turn center rod unti! gearshift lever falls into neutral
lock gate on fender console_
, Tighten locknuts securely.
LEVER
rRAL
LOCK GATE
FIG. 30
_(_ TRANSAXLE
FIG, 31
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 32)
.................... iii ,H ,,111NI i llll ll,ll !l
&
CAUTION: Lead-acid batteries gener-
ate explosive gases. Keep sparks,flame
and smoking materials away from bat-
teries, Always wear eye protection
when around batteries.
ii ,,i i,iii i, ,H,,,,,,, i,
If your battery is too weak to start the engine, it should be
recharged. If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WiTH A
12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM, DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES,,
TO ATTACH JUMPER CABLES -
. Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis,
o Connect one end of the BLACK cable to the NEGA-
TiVE (-) terminal of fully charged battery,
, Connect the other end of the BLACK cable to good
CHASSIS GROUND, away from fuel tank and battery
TO REMOVE CABLES, REVERSE ORDER -
o BLACK cabfe first from chassis and then from the fully
charged battery
RED cable last from both batteries.
"POSITIVE" (+) "NEGATIVE"(=)
ii
L H, PANE: 11 /
;OL,
,
FIG. 32
24