Owner`s manual

SERVICE AN ADJUSTMENTS
TO REPLACE HEADLIGHT BULB
• Raise hood,
o Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
° Close hood,
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting
o Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp automotiveqype plug-in fuse The
fuse holder is located behind the dash
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 33)
o Raise hood,
• Unsnap headlight wire connector.
° Standinfrontoftractor. Grasphoodatsides, titttoward
engine and lift off of tractor,
° To replace, reverse above procedures.
HOOD
/
l " " _" HEADLIGHT
WIRE
CONNECTOR
FIG. 33
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 34)
The throttte contro! has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
= With engine not running, move throttle control lever to
fast (,_) position.
• Check that swivel is against side of quarter circle. If it
is not, loosen cabte clamp screw and pull cable back
until swivef is against quarter circle. Tighten cabie
clamp screw securely
TO ADJUST CHOKE CONTROL (See Fig. 35)
The choke control has been preset at the factory and
adjustment should not be necessary, Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as foIlows:
° With engine not running, move choke control (located
on dash panel) to full choke (N) position.
. Remove air cleaner cover, filter and cartridge plate to
expose carburetor choke (see "AIR FILTER" in the
Customer Responsibilities section of this manual),
o Choke should be closed. If it is not, loosen casing
clamp screw and move choke cable until choke is
compIetety closed Tighten casing clamp screw se-
curely.
o Reassemble air cleaner
CLAMP SCREW
SWIVEL
FIG. 34
CHOKECLOSED_
CLAMP
SCREW
LEVER
25