Owner`s manual

i i in m ill i i n, t J i i H m ¸ u ....Ullll/ IIH ......
ASSEMBLY
r I q U l III _ I I
Use terminal access doors for:
o Lnspection for secure connections (to tighten hard
ware)
o Inspection for corrosion
, Testing battery
o Jumping (if required)
o Periodic charging
LOCK FLAT
HEX NUT_, WASHER WASHER
DISCARD TERMINAL _ HEX
PROTECTIVE CAPS _ BOLT
L
TERM[NAL
ACCESS
DOOR
POSITIVE
(RED)
CABLE
NEGATIVE
(BLACK)
CABLE
FIG. 2
INSTALL SEAT (See Fig 3)
Adjust seat before tightening adjustment bolt
= Remove cardboard packing on seat pan
• Place seat on seat pan and assemble shoulder bolt
= Assemble adjustment bolt lock washer and flat washer
looseiy Do not tighten°
o Tighten shoulder bolt securely
• Lower seat into operating position and sit on seat
Slide seat until a comfortable position is reached which
allows you to press clutchlbrake pedal all the way
down_
o Get off seat without moving its adjusted position,
• Raise seat and tighten adjustment boit securely,,
...................................i nL i u' '1 iH,l,l_,l,r., nl Ul
CHECK TIRE PRESSURE
The tires on your tractor were ovednfiated at the factory for
shipping purposes Correct tire pressure is important for
best cutting performance
o Reduce tire pressure to PSi shown in PRODUCT
SPECIFICATIONS" on page 3 of this manual
CHECK BRAKE SYSTEM
After you learn how to operate your tractor check to see
that the brake is properly adjusted See TO ADJUST
BRAKE in the Service and Adjustments section of this
manual,,
INSTALL IVIULCHER PLATE (See Figs 4 and
5)
o Install two latch hooks to mulcher plate using screw
washer lock washer and weld nut as shown
NOTE: Pre assemble weld nut to latch hook by inserting
weld nut from the top with hook pointing down
o Tighten hardware securely
• Raise and hotd deflector shield in updght position
• Place front of mulcher plate over front of mower deck
opening and slide into place as shown
o Hook front latch into hole on front of mower deck
o Hook rear {arch into hole on back of mower deck
- ,_. CAUTION: Do not remove discharge-_
_ guard from mower. Raise and hold I
guard when attaching mulcher plate I
and allow it to rest on plate while in i
operatic l .........................................
J
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in a safe place
Your mower is now ready for discharging or installation of
optional grass catcher accessory
NOTE: It is not necessary to change blades The mulcher
blades are designed for discharging and bagging also
SEAT
SEAT PAN
BOLT SHER
FIG 3