Product specifications
TROUBLESHOOTII _G CHART
PROBLEM CAUSE
• Loose or damaged wiring.
• Faulty solenoid or starter.
• Cutting too much
grass/too fast.
• Throttle in "CHOKE" posi-
tion.
• Build-up of grass, leaves
and trash under mower.
• Dirty air filter.
• Low oil level/dirty oil.
• Faulty spark plug.
Engine clicks but
will not start (con-
i'd)
Loss of power
Excessive vibration
Engine continues to
run when operator
leaves seat with at-
tachment clutch
engaged
Poor cut - uneven
• Dirty fuel filter.
• Stale or dirty fuel.
• Water in fuel.
• Spark plug wire loose.
• Dirty engine air
screen/fins.
• Dirty/clogged muffler.
• Loose or damaged wiring.
• Carburetor out of adjust-
ment.
• Engine valves OLrtof
adjustment.
• Worn, bent or loose blade.
• Bent blade mandrel.
• Loose/damaged part(s).
• Faulty operator-safety
presence control system.
• Worn, bent or loose blade.
• Mower deck net level.
• Buildup of grass, leaves,
and trash under mower.
• Bent blade mandrel.
• Clogged mower deck vent
holes from buildup of
'CORRECTION
• Check all wiring.
• Check]replace solenoid or
starter.
• Set in "Higher Cut" posi-
tion/reduce speed.
• Adjust throttle control.
I • Clean underside of mower
housing.
• Clean/replace air filter.
I " Check oil level/change oil.
• Clean and regap or change
spark plug.
• Replace fuel filter.
• Drain fuel tank and refill with
fresh gasoline.
• Drain fuel tank and carbure-
tor, refill tank with fresh gaso-
line and replace fuel filter.
• Connect and tighten spark
plug wire.
• Clean engine air screen/fins.
• Clean/replace muffler.
• Check all wiring.
• See "To Adjust Carburetor" in
Service and Adjustments
section.
• Contact an authorized ser-
vice center.
• Replace blade. Tighten blade
bolt.
• Replace blade mandrel.
• Tighten loose part(s).
Replace damaged parts.
• Check wiring, switches and
connections. If not
corrected, contact an autho-
rized service center.
• Replace blade. Tighten blade
bolt.
• Level mower deck.
I • Clean underside of mower
housing.
• Replace blade mandrel.
• Clean around mandrels to
open vent holes.
3O