Owner`s manual

DO NOT WEAR WATCHES, RINGS OR LOOSE CLOTHING WHILE INSTALLING OR SERVICING A DOOR OPENER.
SECTIONAL DOOR & 1-PIECE DOOR WITH TRACK
1. Close door and mark the inside vertical centerline of
garage door.
Extend the line onto header wall above door.
2. Open door to highest point of travel as shown. Draw an
intersecting horizontal line on header wall 2" above high
point. This height will provide travel clearance for top
edge of door.
NOTE: When the headroom Is not sufficient for 2"
clearance, the bottom edge of bracket may be placed
In line with the door's high point of travel.
Proceed to Step 2, Page 11.
Installation procedures vary according to garage door types.
Follow the instructions which apply to your door.
Position and Install Header Bracket
INSTALLATION STEP 1
THE HEADER BRACKET MUST BE RIGIDLY
FASTENED TO HEADER WALL REINFORCE
WALL WITH A 2x4 IF NECESSARY. FAILURE TO
COMPLY MAY RESULT IN IMPROPER
OPERATION OF SAFETY REVERSE SYSTEM
(SEE PAGE 22).
KEEP GARAGE DOOR BALANCED. STICKING OR BINDING DOORS MUST BE REPAIRED. THE GARAGE DOOR, DOOR
SPRINGS, CABLES, PULLEYS, BRACKETS AND THEIR HARDWARE ARE UNDER EXTREME TENSION AND CAN CAUSE
SERIOUS PERSONAL INJURY. DO NOT ATTEMPT TO LOOSEN, MOVE OR ADJUST THEM. CALL FOR GARAGE DOOR
SERVICE.
BEFORE BEGINNING INSTALLATION OF GARAGE DOOR OPENER, BE SURE TO COMPLY WITH ALL SAFETY RULES IT IS
RECOMMENDED THAT THE OPENER BE INSTALLED 7 FEET OR MORE ABOVE FLOOR WHERE SPACE PERMITS.
10
3. Position bracket as shown (centered on vertical
guideline with bottom edge of bracket on horizontal
line).
Mark either top and bottom or left and right bracket
holes. drill 3/16" pilot holes and fasten bracket.