Owner`s manual

ONE-PIECE DOOR WITHOUT TRACK
PLEASE READ AND COMPLY WITH THE WARNINGS ON PAGE 10. THEY APPLY TO THE INSTALLATION OF THE
HEADER BRACKET REGARDLESS OF DOOR TYPE.
1. Close door and mark inside vertical centerline of
garage door Extend line onto header wall above
door.
2. Open door to highest point of travel as shown.
Measure the distance from top of door to floor.
Subtract actual height of door. Add 8" to
remainder {see example).
NOTE: If the total number of inches exceeds height
available In garage use the maximum height
possible. On finished ceilings do not position the
bracket closer than 1/2" from ceiling.
EXAMPLE
Distance from top of door (at
highest point of travel) to floor............................ 92”
Actual height of door ......................................... -88”
Remainder . . .................................................... 4”
Add ................................................................... + 8”
Bracket height on header wall ............................ =12”
(Measure UP from top of CLOSED door.)
POSITION AND FASTEN HEADER BRACKET AS
DESCRIBED AND SHOWN IN NO. 3 ON PAGE 10.
ONE-PIECE DOOR - NO TRACK
PIVOT HARDWARE
ONE-PIECE DOOR - NO TRACK
JAMB HARDWARE
INSTALLATION STEP 2
.
Attach the T-Rail to Header Bracket
PROCEDURE: Position opener on garage floor below
header bracket. Use packing material as a protective
base.
NOTE: To enable T-rail to clear sectional door
springs It may be necessary to lift opener onto a
temporary support.
CAUTION: The opener must either be secured to a
support or held firmly In place by another person.
Raise T-rail until pulley and header brackets come
together. Align bracket holes and join with clevis pin as
shown. Insert ring fastener to secure.
11