Owner`s manual

LOCATE DOOR CONTROL BUTTON (OR ANY ADDITIONAL PUSH BUTTONS) WHERE THE GARAGE DOOR IS VISIBLE,
AWAY FROM DOOR AND DOOR HARDWARE AND OUT OF THE REACH OF CHILDREN. SERIOUS PERSONAL INJURY
FROM A MOVING GARAGE DOOR
MAY RESULT FROM MISUSE OF OPENER.
DO NOT ALLOW CHILDREN TO OPERATE DOOR CONTROL BUTTON(S) OR REMOTE CONTROL TRANSMITTER. FASTEN THE
CAUTION LABEL ON THE WALL NEAR DOOR CONTROL BUTTON AS A REMINDER OF SAFE OPERATING PROCEDURES.
INSTALLATION STEP 5
Install Lighted Door Control Button
OPERATION OF
LIGHTED DOOR CONTROL BUTTON
WIRING INSTRUCTIONS FOR ACCESSORIES
Press to open or close door.
Press again to REVERSE door during the CLOSING
cycle or to STOP door during OPENING cycle.
The Protector System
To white and black opener terminals
Outdoor Key Switch:
To red and white opener terminals
Remove about 1/4” of insulation from both
ends of 2-strand bell wire. Connect one end to
both screw terminals on back of lighted door
control as shown.
NO POLARITY IS REQUIRED.
Install the door control button on an inside
garage wall as shown. Use anchors if
installing into drywall. A convenient place is
alongside the service door and
OUT OF REACH OF CHILDREN.
Run bell wire up the wall and across the
ceiling to the opener. Secure with insulated
staples.
Receiver terminals and antenna are located on
back panel of opener. Position antenna wire
as shown. Then connect the wire by color to
the white and red opener terminal screws.
14