Owner`s manual

INSTALLATION STEP 6

Install Light and Lens

INSTALLING LIGHT: Install a 75 watt maximum light

bulb in socket as shown. The light will turn on and

remain lit for 4-1/2 minutes when power is connected.

After 4-1/2 minutes it will turn off.

If bulb burns out prematurely due to vibration, replace

with bulb specifically packaged for “Garage Door

Openers”.

INSTALLING LENS: Slide the lens into the guides as

shown. Snap the bottom tabs into lens slots.

INSTALLATION STEP 7

Attach Manual Release Rope and Handle

PROCEDURE: Thread one end og rope through hole

in top of red handle so ‘NOTICE’ reads right side up as

shown. Secure with an overhand knot.

NOTE: Knot should be at least 1” from end of the

rope to prevent slipping.

Thread other end of rope through hole in release arm

of outer trolley. Adjust rope llength so that handle is 6

feet above the floor. Secure with an overhand knot as

above.

NOTE: If it is necessary to cut rope, heat seal cut

end with match or lighter to prevent fraying and/or

raveling.

USE THE MANUAL RELEASE ROPE ONLY

TO DISENGAGE TROLLEY. DO NOT USE

ROPE AND HANDLE TO PULL THE DOOR

OPEN OR CLOSED.