Owner`s manual

TO AVOID SERIOUS PERSONAL INJURY
FROM ENTANGLEMENT, REMOVE ALL THE
ROPES CONNECTED TO GARAGE DOOR
BEFORE OPERATING OPENER
TO AVOID DAMAGE TO GARAGE DOOR AND
OPENER, MAKE DOOR LOCKS INOPERATIVE
BEFORE CONNECTING ELECTRIC POWER. USE A
WOOD SCREW OR NAIL TO HOLD LOCKS IN "OPEN"
(UNLOCKED) POSITION.
THE INSTALLATION & THE WIRING MUST BE IN
COMPLIANCE WITH LOCAL ELECTRICAL AND
BUILDING CODES.
OPERATION AT OTHER THAN 120V 60Hz WILL
CAUSE OPENER MALFUNCTION AND DAMAGE.
Opener Must be permanently wired or plugged into
a grounded 3-prong receptacle wired according to
local electrical codes. DO NOT use a 2-wire adapter.
DO NOT USE an extension cord.
RIGHT WRONG
PROCEDURE FOR PERMANENT WIRING (if required by local codes)
DISCONNECT THE POWER AT THE FUSE
BOX BEFORE PROCEEDING.
Refer to illustration. Make connection through the 7/8
diameter hole in top of opener.
1. Remove opener cover screws and set cover aside.
2. Remove attached 3-prong cord.
3. Connect black (line) wire to black wire on terminal
block; white (neutral) wire to white terminal wire;
green (ground) wire to green ground screw.
CAUTION: BE SURE THE UNIT IS GROUNDED ACCORDING
TO LOCAL CODE.
IMPORTANT NOTE TO AVOID INSTALLATION DIFFICULTIES,
DO NOT RUN OPENER NOW.
16
INSTALLATION STEP 8
Connect Electric Power